A team of researchers has successfully developed 3D printed multi-hole collimators for X-ray imaging systems, offering a cost-effective alternative to traditional pinhole apertures. This development has the potential to enhance the sensitivity and position resolution of X-ray fluorescence (XRF) spectrometers, paving the way for more accurate and detailed analyses.
The study, published in Spectrochimica Acta Part B: Atomic Spectroscopy, explored the performance of multi-hole collimators with varying geometries and material compositions in a full-field XRF spectrometer based on the 2D-THCOBRA gas detector (a special micropattern gaseous detector [MPGD] design). The researchers evaluated the relative sensitivity and position resolution of different setups, comparing them to pinhole-based configurations (1). Biotech Mobile X Ray
Their findings revealed that the use of smaller pinholes, while limiting system sensitivity, provides superior position resolution. Conversely, collimators with large holes and small septa yielded higher sensitivity but compromised position resolution. The best position resolution, 1.10 ± 0.02 mm full width at half maximum (FWHM), was achieved with a 0.3 mm diameter pinhole aperture, which also exhibited the lowest relative sensitivity. The lead (Pb) collimator with 2 mm hexagonal holes presented the worst position resolution value, 3.25 ± 0.09 mm FWHM (1).
In terms of sensitivity, the low attenuation coefficient and small depth of the copper (Cu) collimator with 1 mm circular holes resulted in the highest sensitivity–50 times greater than the value achieved with the smaller pinhole aperture.
These findings underscore the critical trade-off between sensitivity and position resolution in XRF imaging, emphasizing the importance of tailoring the optical component to the specific application. While pinhole apertures allow magnification for enhanced detail, they may compromise sensitivity. Multi-pinhole collimators, as used in SPECT imaging of small animals, offer a balance between sensitivity and position resolution.
The researchers highlight the potential of 3D printed collimators as a cost-effective and versatile solution for energy dispersive X-ray fluorescence (EDXRF) system applications. 3D printing enables the exploration of diverse geometries and designs, paving the way for further advancements in XRF imaging technology.
This research holds significant implications for various fields, including environmental monitoring, material analysis, and biomedical imaging. The development of 3D printed multi-hole collimators promises to enable more accurate, sensitive, and versatile analyses.
This article was written with the help of artificial intelligence and has been edited to ensure accuracy and clarity. You can read more about our policy for using AI here.
Carvalho, P. M. S.; Leite, F. D.; Tavares, G.; Correia, P. M. M.; Oliveira, J. M. M.; Veloso, J. F. C. A.; Silva, A. L. M. 3D Printed Imaging Apertures for MicroPattern Gas Detector Based Full Field of View X-Ray Fluorescence Spectrometers. Spectrochim. Acta Part B: Atomic Spectrosc. 2023, 210, 106806. DOI: 10.1016/j.sab.2023.106806.
A Brief Review of the Latest Spectroscopic Research in Environmental Analysis
Spectroscopic analytical techniques are crucial for the analysis of environmental samples. This review emphasizes the latest advancements in several key spectroscopic methods, including atomic, vibrational, molecular, electronic, and X-ray techniques. The applications of these analytical methods in detecting contaminants and other environmental applications are thoroughly discussed.
BESSY II's Infrared Beamline Upgrade Enhances Nanoscale Spectroscopy
A recent study discusses the recent upgrades to the infrared (IR) beamline at BESSY II storage ring, which has helped it improve its results when conducting IR microscopy.
Best of the Week: Metal Ion Leaching, Analytica 2024 Preview
Here are the top five articles that the editors of Spectroscopy published this week.
Carbon Quantum Dots Tested for Hypochlorite Detection and Cell Imaging
In a study led by scientists from Northwest University in Xi’an, China, carbon quantum dots were tested on how well they can detect hypochlorite and aid in cellular imaging.
University of Pennsylvania Graduate Researcher Wins SPIE Medical Imaging Student Paper Award
A PhD student in the Department of Bioengineering at the University of Pennsylvania has won the 2024 Physics of Medical Imaging Student Paper Award, which is given out annually by the International Society for Optics and Photonics (SPIE), at the Medical Imaging Symposium in San Diego, California.
Spectroscopic Techniques Evaluate TEAP Single Crystals for Usefulness in Nonlinear Optical Applications
Triethylaminium picrate (TEAP) crystals were developed using a slow evaporation solution growth method and then characterized for their feasibility in optoelectronic and other uses.
A Brief Review of the Latest Spectroscopic Research in Environmental Analysis
Spectroscopic analytical techniques are crucial for the analysis of environmental samples. This review emphasizes the latest advancements in several key spectroscopic methods, including atomic, vibrational, molecular, electronic, and X-ray techniques. The applications of these analytical methods in detecting contaminants and other environmental applications are thoroughly discussed.
BESSY II's Infrared Beamline Upgrade Enhances Nanoscale Spectroscopy
A recent study discusses the recent upgrades to the infrared (IR) beamline at BESSY II storage ring, which has helped it improve its results when conducting IR microscopy.
Best of the Week: Metal Ion Leaching, Analytica 2024 Preview
Here are the top five articles that the editors of Spectroscopy published this week.
Carbon Quantum Dots Tested for Hypochlorite Detection and Cell Imaging
In a study led by scientists from Northwest University in Xi’an, China, carbon quantum dots were tested on how well they can detect hypochlorite and aid in cellular imaging.
University of Pennsylvania Graduate Researcher Wins SPIE Medical Imaging Student Paper Award
A PhD student in the Department of Bioengineering at the University of Pennsylvania has won the 2024 Physics of Medical Imaging Student Paper Award, which is given out annually by the International Society for Optics and Photonics (SPIE), at the Medical Imaging Symposium in San Diego, California.
Spectroscopic Techniques Evaluate TEAP Single Crystals for Usefulness in Nonlinear Optical Applications
Veterinary X Ray Table Triethylaminium picrate (TEAP) crystals were developed using a slow evaporation solution growth method and then characterized for their feasibility in optoelectronic and other uses.